Buy Low Price From Here Now
Arbor Presses Machine Type: Mechanical Pressure: 1
Readmore
Technical Details
- 1-ton manual arbor press delivers heavy force needed for riveting, squeezing, punching, bending, and other pressing applications- Removable machined steel anvil provides accurate work support in 4 slot positions
- Sturdy cast-iron construction
- Equipped with a hand wheel to perform light and quick press work
- Base drilled for mounting on bench or pedestal.
See more technical details
By James Dingman (Wisconsin, USA)
The first thing that I noticed was that the Palmgreen press was very lightweight compared to my other 1 ton arbor presses. Not sure if this is good or bad, depends on the strength of the iron used on these units. We will see how it stands up in the long run.
The first press that I received was cracked in the center of the base both sides of the base. This was a factory defective casting that was "hidden" by paint and passed on to the unsuspecting consumer, me! I did not see the cracks until I mounted the press and big chunks of paint flaked of both sides where the base flexed. Good think I noticed it before I put the press into service or I might have got a facefull of press as it let loose under pressure! Currently waiting for the replacement.
AS to the quality of the unit I was not particularly impressed. I have a couple of other Taiwan and China presses in my shop and overall they are better quality than this Palmgreen and cost almost half as much. My main concern, other than the cracked base, is the lack of gibes for the post. On both of my Oriental units the center drive post rides on brass plates that are loosened and tightened by the set screws in the front plate and the side of the unit. On the Palmgreen the column rides directly on the ends of the set screws which is not a good thing as all the pressure is concentrated on the face of the 1/4 inch screws and will result in rapid wear and grooving on the face of the post! Another quality issue I have with this unit is that the side of the post was never finished after the teeth were cut and there were rough burrs all up and down the post which dragged on the casting. I expect this kind of thing from cheep Taiwan machine work but not a highly touted American Made unit.
Overall, not impressed!
By Mr. Fixit (Dallas TX)
This arbor press is just what I needed. It's small, it fits on top of a workbench nicely, and it is very well-made.
By J. Galloway (TX USA)
This arbor press has excellent features and is a quality, built-in-the-USA unit. I especially like the hole in the ram so that tool tips of different shapes can be attached. It uses a magnet to hold them in place. I made my own attachement to use this as a leather stamping press and it works great. I found that if you make your own tool tip that you need to carefully copy the ones provided so that the length of the mounting hole portion does not extend further and come in contact with the magnet. I would recommend this product to anyone.
By John Russo (Chester, New Hampshire United States)
I know, I know, he's going to talk about cast iron again. Sorry folks, it's the only way to go. This little benchtop unit is great for small press jobs...bearings, dowels, roll pins, etc.
By George Lamb (West Virginia)
Much, much better than the typical Chinese made generic arbor press. Good fit and finish, includes accessories that most do not. Was very pleasantly surprised at the overall quality and value. Highly recommended.
Images Product
Buy Palmgren 61101 AP10 1-Ton Manual Arbor Press Now
0 Response for the "Palmgren 61101 AP10 1-Ton Manual Arbor Press"
Post a Comment